Pricing guide
How to Bid on Shopping Mall Common Area Cleaning
Worked example
$16,288a month
Shopping Mall / Common Areas, 150,000 sq ft, 7x per week, with a $15.00 hourly wage.
See how it adds up- Typical size
- 50,000 to 500,000 sq ft of common area
- Usual frequency
- 7x per week with daytime porter service and overnight deep cleaning
What to watch for.
Massive floor area requiring equipment
You cannot mop 200,000 sq ft of mall corridors by hand. Ride-on floor scrubbers, industrial burnishers, and commercial carpet extractors are required. The equipment investment for a single mall contract is large. Many contractors rent equipment for their first mall account, but the cost needs to be in the bid.
Food court cleanup
Mall food courts generate heavy grease, food debris, and trash. Tables need constant wiping during operating hours (day porter work), and floors need nightly degreasing. Food court restrooms see the heaviest use in the mall. A food court adds labor cost out of proportion to its square footage.
Daytime porter coverage across multiple zones
Malls need visible cleaning staff during operating hours: restroom checks, spill cleanup, food court busing, entrance maintenance. Porters need to cover multiple zones efficiently. Scheduling and supervising a daytime porter team across a sprawling mall requires an on-site supervisor, which adds management cost.
Holiday and seasonal surges
Holiday foot traffic in a mall is a multiple of normal levels. Extended holiday hours mean more cleaning time. Most mall contracts include provisions for seasonal staffing increases. Budget for additional labor during November and December and plan your staffing surge in advance.
How long the work takes.
The worked example starts from times based on ISSA's 540 Cleaning Times: wet mopping at 2,500 sq ft per hour, restrooms at 3 minutes per fixture, trash removal at 80 cans per hour, lobby cleaning at 15 minutes per lobby, elevators at 12 minutes per cab, stairwells at 15 minutes per floor.
SolidBid applies a difficulty multiplier for this facility type (the range is 0.7-1x, and the calculator uses the low end).
Nightly vacuuming and mopping cover traffic lanes and entrances (about 30% of the floor), and weekly tasks such as dusting are spread across the week's visits. Project work is quoted separately and is not in the monthly price: window cleaning (interior).
Ride-on scrubbers cover far more floor per hour than the hand-mop rate, so a contractor with the machines can price corridors lower. Day porter coverage is priced by hours and is outside the monthly price.
A worked example.
A 150,000 sq ft shopping mall common area including 100,000 sq ft of corridors, a 20,000 sq ft food court, 15,000 sq ft of entrance and lobby areas, 10,000 sq ft of restrooms (16 restrooms), and 5,000 sq ft of elevator and stairwell space (8 elevators, 6 flights of stairs). Cleaned 7 nights per week. Daytime porter coverage is quoted separately and is not in the monthly price.
| Line and how it’s worked out | Per month |
|---|---|
| Labor18.55 hours a visit × 30.31 visits a month × $15.00 an hour, plus 30% for payroll taxes and workers’ comp | $10,964 |
| Supplies$0.01 per sq ft a month for paper, soap, liners and chemicals | $1,500 |
| Overhead15% of labor and supplies, for the van, equipment, insurance and office | $1,870 |
| Profit12% of the final price, a true margin rather than a markup | $1,954 |
| Monthly price$0.109 per sq ft a month | $16,288 |
What the price covers
- Mopping (Wet): 45,000 sq ft of traffic lanes and entrances, every visit
- Restroom Cleaning: 48 fixtures, every visit
- Trash Removal: 300 trash cans, every visit
- Lobby / Entrance Cleaning: 1 lobby, every visit
- Elevator Cleaning: 8 elevators, every visit
- Stairwell Cleaning: 6 floors, weekly
- Quoted separately, not in the monthly price: Window Cleaning (Interior)
This is an example, not a quote. Wages, building conditions, restroom counts and scope all move the price, and the calculator lets you change each one.
Price this building with your own numbers.
The calculator starts from this example: 150,000 sq ft at 7x per week, with the same wage, margin and counts, so it shows the same price. Then enter what you pay and change anything that doesn’t match the building you’re bidding.
What buildings like this usually cost.
Benchmark range
$0.09 - $0.13 per sq ft per month at 7 visits a week
Where it comes from
An estimate from SolidBid's cost model, not a published rate
A price outside the range isn’t wrong on its own. Wages, restroom counts and scope move it. The calculator’s price check shows where a price sits against a range like this one.
Common scope of work.
- Machine scrub all mall corridor floors nightly
- Degrease and scrub food court floors nightly
- Clean all entrance and lobby areas (glass, mats, floors)
- Clean and sanitize all restrooms nightly (full deep clean)
- Daytime restroom porter rounds (minimum every 2 hours)
- Clean all elevators (cab walls, tracks, buttons, floors)
- Clean all stairwells (sweep, mop, dust handrails)
- Empty all trash receptacles throughout the mall
- Daytime food court busing and table wiping
- Daytime spill response and entrance maintenance
- Monthly: high dusting of common area ceilings, directional signage cleaning
- Quarterly: corridor floor refinishing, deep carpet extraction, window cleaning
Get the walkthrough checklist for shopping mall common area cleaning
A free printable PDF to fill in on site: the counts the calculator asks for, the questions that change the price, and a page for notes and a floor sketch.
We’ll also send occasional emails about pricing cleaning bids. Unsubscribe any time.
Common questions.
How much does shopping mall cleaning cost?
In the worked example above, a 150,000 sq ft mall common area cleaned nightly comes to about $16,288 a month for the base cleaning. Daytime porter coverage is quoted separately. Porters are priced by the hour (hours x burdened wage), so the cost depends on how many porters you staff and for how many hours.
What equipment do I need for mall cleaning?
At minimum: one ride-on floor scrubber, a burnisher for hard floor maintenance, a commercial carpet extractor, backpack vacuums, and industrial mop systems. For larger malls, you may need multiple ride-on machines. Equipment rental is an option for your first mall contract, since many dealers offer monthly rental. Build equipment costs into your bid as a line item.
How do I handle staffing surges during the holidays?
Plan for a staffing increase during November and December. Start recruiting temporary staff in September. Your contract should include a holiday surge clause that either builds the extra cost into the annual flat rate or allows for monthly billing adjustments during peak months. Most mall property managers expect and budget for seasonal increases. The key is defining it in the contract upfront.
Keep reading.
- How to Calculate Commercial Cleaning Costs (2026 Guide)Plenty of cleaning contractors lose money on a contract because they guessed instead of calculating. Here is the step-by-step math behind a defensible commercial cleaning price.
- ISSA Cleaning Times Explained: What Every Contractor Should KnowISSA's 540 Cleaning Times are a widely used reference for estimating janitorial labor. If you are bidding without production rates, you are guessing. Here is what they are and how to use them.
- Commercial Cleaning Pricing: The Complete Per-Square-Foot GuidePer-square-foot pricing is the industry's common yardstick for commercial cleaning. Here are published benchmarks by facility type, what affects the rate, and how to use the numbers.
- How SolidBid works out a priceThe method, the sources, and what a price can’t know about your building.
Pricing guides for other buildings.
Office
Medical
Education
Financial
Property Management
Religious
Price this building now. It’s free.
No signup to see the price. When it’s right, the Bid Kit turns it into a proposal ready to send.
Open the calculator