Pricing guide
How to Bid on Bar and Nightclub Cleaning
Worked example
$2,074a month
Bar / Nightclub, 3,500 sq ft, 7x per week, with a $18.00 hourly wage.
See how it adds up- Typical size
- 1,500 to 10,000 sq ft
- Usual frequency
- 7x per week (every night they are open)
What to watch for.
Extreme floor conditions
After a busy night, bar floors are covered in spilled beer, cocktails, sticky syrups, and sometimes broken glass. Standard mopping is not sufficient. You need hot water, heavy-duty degreaser, and potentially a floor machine. Some floors need two passes. The floor surface (concrete, tile, wood) determines your approach, but all of them will be disgusting by closing time.
Restroom devastation
Bar restrooms at closing time are in worse condition than any other commercial facility. Expect overflowing trash, wet floors, clogged toilets, and general mess that goes beyond normal commercial restroom cleaning. Budget well above the standard 3 minutes per fixture and use heavy-duty disinfectants. PPE (gloves, potentially face masks) is essential.
Late-night/early-morning hours
Bars close at 1-2 AM, and your crew starts after staff leave (typically 2:30-3 AM). The work needs to be done by opening time (11 AM-4 PM depending on the venue). This means early morning shifts with potential overnight differential pay. Finding reliable workers willing to clean bars at 3 AM is one of the biggest operational challenges.
Broken glass and safety hazards
Broken glass is a nightly reality in bars. Your crew needs cut-resistant gloves, proper glass disposal containers, and training on safe broken glass cleanup. Wet, slippery floors with invisible glass shards are a serious injury risk. Good lighting and methodical cleaning protocols prevent worker injuries.
How long the work takes.
The worked example starts from times based on ISSA's 540 Cleaning Times: wet mopping at 2,500 sq ft per hour, restrooms at 3 minutes per fixture, restroom deep cleaning at 37 minutes per restroom, trash removal at 80 cans per hour, surface disinfecting at 2,750 sq ft per hour.
SolidBid applies a difficulty multiplier for this facility type (the range is 1.4-2x, and the calculator uses the low end).
Nightly vacuuming and mopping cover traffic lanes and entrances (about 30% of the floor), and weekly tasks such as dusting are spread across the week's visits. Project work is quoted separately and is not in the monthly price: wall washing / spot cleaning.
Sticky floors, broken glass, and restroom abuse make bars slower than the standard times assume. Wall washing is quoted separately.
A worked example.
A 3,500 sq ft bar with a 2,000 sq ft main floor and bar area, a 500 sq ft stage and dance area, a 500 sq ft entrance and lounge, and 500 sq ft of restrooms and storage. 2 restrooms. Cleaned 7 nights per week after closing. Floor: 80% sealed concrete and rubber (hard floor), 20% tile. Wall washing is quoted separately. At $0.593 per sq ft this example sits about 11% above the top of the printed range, an estimate from SolidBid's cost model; SolidBid's price check still counts it as within range, because it allows 15% either side.
| Line and how it’s worked out | Per month |
|---|---|
| Labor2.04 hours a visit × 30.31 visits a month × $18.00 an hour, plus 30% for payroll taxes and workers’ comp | $1,444 |
| Supplies$0.01 per sq ft a month for paper, soap, liners and chemicals | $35 |
| Overhead15% of labor and supplies, for the van, equipment, insurance and office | $222 |
| Profit18% of the final price, a true margin rather than a markup | $373 |
| Monthly price$0.593 per sq ft a month | $2,074 |
What the price covers
- Mopping (Wet): 1,050 sq ft of traffic lanes and entrances, every visit
- Restroom Cleaning: 6 fixtures, every visit
- Restroom Deep Cleaning: 6 fixtures, monthly
- Trash Removal: 7 trash cans, every visit
- Sanitizing / Disinfecting: 1,050 sq ft of traffic lanes and entrances, every visit
- Quoted separately, not in the monthly price: Wall Washing / Spot Cleaning
This is an example, not a quote. Wages, building conditions, restroom counts and scope all move the price, and the calculator lets you change each one.
Price this building with your own numbers.
The calculator starts from this example: 3,500 sq ft at 7x per week, with the same wage, margin and counts, so it shows the same price. Then enter what you pay and change anything that doesn’t match the building you’re bidding.
What buildings like this usually cost.
Benchmark range
$0.28 - $0.535 per sq ft per month at 7 visits a week
Where it comes from
An estimate from SolidBid's cost model, not a published rate
A price outside the range isn’t wrong on its own. Wages, restroom counts and scope move it. The calculator’s price check shows where a price sits against a range like this one.
Common scope of work.
- Sweep and degrease all floor surfaces with hot water and heavy-duty degreaser
- Clean and sanitize bar top, rail, and back bar surfaces
- Wipe and sanitize all tables, booths, and seating
- Deep clean and disinfect all restrooms (floors, fixtures, walls, restock)
- Sweep and safely dispose of all broken glass
- Empty all trash receptacles and replace liners
- Clean behind bar (floor, under speed rail, sink area)
- Clean dance floor/stage area
- Wipe down walls at bar height (splash zone)
- Clean entrance glass, doors, and vestibule
- Monthly: deep wall washing, booth detail cleaning, baseboard scrubbing
- Quarterly: floor machine deep scrub, drain treatment, ceiling/light fixture cleaning
Get the walkthrough checklist for bar and nightclub cleaning
A free printable PDF to fill in on site: the counts the calculator asks for, the questions that change the price, and a page for notes and a floor sketch.
We’ll also send occasional emails about pricing cleaning bids. Unsubscribe any time.
Common questions.
How much does bar cleaning cost per month?
In the worked example above, a 3,500 sq ft bar cleaned nightly after closing comes to about $2,074 a month. The per-square-foot rate is among the highest in commercial cleaning because of the extreme floor conditions, heavy restroom abuse, late-night hours, and physical intensity of the work. Nightclubs with larger dance floors and VIP areas cost more.
How do I staff bar cleaning when the hours are 3 AM starts?
Bar cleaning crews are a specialized labor pool. Look for workers who prefer overnight shifts. There are more than you might think. Pay a premium over your standard cleaning rate to attract reliable overnight workers. Some contractors pair bar cleaning with early-morning office cleaning so workers get a full shift (3 AM-9 AM). Retention is the real challenge. Invest in workers who stick around.
Should I use a floor machine for bar floor cleaning?
For bars over 2,000 sq ft, a walk-behind auto-scrubber dramatically improves efficiency and cleaning quality. It replaces the two-pass mop process with a single machine pass that scrubs, squeegees, and recovers dirty water. A walk-behind scrubber is a real purchase, so check the numbers against the length and price of the contract before you buy. For smaller bars, manual mopping with a good degreaser is adequate.
Keep reading.
- How to Calculate Commercial Cleaning Costs (2026 Guide)Plenty of cleaning contractors lose money on a contract because they guessed instead of calculating. Here is the step-by-step math behind a defensible commercial cleaning price.
- ISSA Cleaning Times Explained: What Every Contractor Should KnowISSA's 540 Cleaning Times are a widely used reference for estimating janitorial labor. If you are bidding without production rates, you are guessing. Here is what they are and how to use them.
- Commercial Cleaning Pricing: The Complete Per-Square-Foot GuidePer-square-foot pricing is the industry's common yardstick for commercial cleaning. Here are published benchmarks by facility type, what affects the rate, and how to use the numbers.
- How SolidBid works out a priceThe method, the sources, and what a price can’t know about your building.
Pricing guides for other buildings.
Office
Medical
Education
Financial
Property Management
Religious
Price this building now. It’s free.
No signup to see the price. When it’s right, the Bid Kit turns it into a proposal ready to send.
Open the calculator